Izolace na klíč 775 654 443

Liquid waterproofing: when it is enough

Coating and slurry waterproofing is cheap, available and tempting to use for things it cannot handle. Here is the line between what these products can do and where they only postpone the problem by one season.

What gets sold under the name

Liquid waterproofing is an umbrella term for several different products applied by brush, roller or trowel that form a continuous layer with no joints. It covers rubberised bitumen coatings, cementitious slurries with polymer, one and two component systems, and products marketed as liquid membranes. They differ in the substrate they belong on and, above all, in the loading they can take.

The shared advantage is that the layer has no joints, can be carried over complicated details and is within reach of a capable owner. The shared disadvantage is that quality depends entirely on preparing the substrate and keeping to the thickness, and neither can be checked once it has cured.

Where it is normally used

  • Under tiles in bathrooms and shower areas. The most common use by far.
  • Balconies and terraces. Under tiles, with movement joints and drainage resolved.
  • Details and penetrations. Places where a sheet would be hard to run.
  • As a complement to sheet waterproofing. At transitions and in internal corners.

Where it is not enough

  • Against water under pressure. This is the main limit. A coating on the inside of a cellar wall with water pushing against it will eventually be torn off.
  • On a damp, salt-laden substrate. It will not bond, or it comes away taking the plaster surface with it.
  • As a substitute for a horizontal barrier. A coating does not stop rising damp, it only moves it above the coated band.
  • As a substitute for substructure waterproofing. Where excavation is involved, systems rated for ground moisture and backfill loading are used.

What to keep to when applying it

  1. Substrate. Sound, clean, dust free, with no remains of old coatings, dry or damp according to what the manufacturer requires.
  2. Primer. Almost always. Skipping the primer is the most common reason coatings peel.
  3. Number of coats and thickness. Follow the data sheet, not how much is left in the bucket.
  4. Details. Internal corners, external corners, penetrations and movement joints are handled with tapes and preformed pieces; the coating alone cracks there.
  5. Curing time. Tiles go on only after the time the manufacturer states.

We deliberately give no thicknesses or times here. They differ between products and quoted from memory they would only confuse you. What always applies is the data sheet of the specific product in your hands.

When to call a contractor

Liquid waterproofing in a bathroom is within reach of a competent DIYer. As soon as the substructure, a permanently damp substrate or water under pressure is involved, it stops being about a product and becomes about designing a build-up, and there doing it yourself does not pay. If you are dealing with a damp cellar or damp walls, start by establishing the cause, not by buying a coating.

Tell us where it is damp

A few sentences are enough. We read every enquiry, fill in the missing details with you and pass it to a company that does damp proofing in your area. If we have nobody there, we say so straight away instead of leaving you waiting.

Prefer to call? 775 654 443

Only the e-mail is required. Add a phone number if you would rather sort the details out by phone.